Dosage form note · powder sticks

Powder Sticks & Drink Mixes

Dissolution, taste and moisture decide the stick pack

The brief

A stick pack is a small, dry blend that has to dissolve in water and taste acceptable at the other end. Particle size controls the dissolution rate and the sediment left in the glass; a 40-mesh crystalline grade dissolves quickly, while a coarse or granulated lot may need more agitation. The 5% suspension is alkaline, so the acid system, flavour and colour have to be selected against pH before addition. Moisture is the other constraint: the chelate is hygroscopic, and a stick pack with a poor moisture barrier cakes at the fold. Uniformity per stick is arithmetic: 100 mg elemental magnesium needs about 710 mg of a 14% chelate. Rainwood supplies the powder; stick filling sits with your manufacturer.

Single-serve stick packsSachetsInstant drink mixesElectrolyte powder blendsMulti-serve powder tubs

Matched ingredients

What changes in this format

Three constraints, one grade decision.

The same powder can pass one constraint and fail another. The trial should test all three.

Dissolution is a particle-size question

A 40-mesh crystalline grade dissolves quickly in water, but a granulated lot wets more slowly and may leave sediment. Milling to 80 mesh raises the dissolution rate and the dust level at the same time. Ask for the particle size on the lot and test dissolution in the intended drink.

Taste follows pH and mineral load

The 5% suspension is alkaline, and an acidic flavour system will neutralise part of that alkalinity and change the taste. Magnesium salts also carry their own bitterness, which rises with the mineral load per stick. Taste has to be tested in the finished drink, not in a dry blend.

Moisture, caking and the seal

The chelate is hygroscopic, and a stick pack has a high surface-to-mass ratio. Powder trapped in the seal can draw moisture and cause caking at the fold, even when the film is adequate. Specify the loss on drying, the packaging film and the filling-room humidity together.

Uniformity per stick is arithmetic

A 100 mg elemental magnesium claim needs about 710 mg of a 14% chelate in each stick, before flavour and carrier. At that mass, a small weighing error is a large relative error in the claim. Blend uniformity and fill accuracy belong in the specification alongside the chemistry.

Ingredients for this application

Starting points, not a shortlist limit.

Every grade is quoted against the specification and the process, not against the application label.

Next step

Describe the finished product. We will name the grade.

The dose, the process step, the taste and the destination are enough to start a specification review.