Dosage form note · gummies and chews

Gummies & Chews

Heat, water activity and pH set the limits in a chewy matrix

The brief

Gummies and chews put a water-soluble, alkaline powder into a hot matrix with its own pH and sugar profile, and the matrix usually decides the outcome. Glycine is 84–88% of the chelate by mass, so a reducing sugar plus heat and residual moisture can drive Maillard browning before the piece cools. The 5% suspension pH of 8.5–11.5 has to be reconciled with the pectin or gelatin set, and water activity controls whether the powder dissolves or stays gritty. Load is also arithmetic: 100 mg elemental magnesium needs about 710 mg of a 14% chelate, which is a large fraction of a small piece. Rainwood supplies the powder; gummy production sits with your manufacturer.

Pectin gummiesGelatin gummiesStarch-moulded gummiesSoft chewsSugar-free chews

Matched ingredients

What changes in this format

Three constraints, one grade decision.

The same powder can pass one constraint and fail another. The trial should test all three.

Heat and reducing sugars

Glycine makes up 84–88% of the chelate, and glycine reacts with reducing sugars under heat and residual moisture. The result can be a brown tint or a flavour change that the assay does not show. A cook curve and a colour check should be part of the trial, not an afterthought.

pH and the gelling system

The 5% suspension is alkaline at pH 8.5–11.5, while pectin sets under acidic conditions and gelatin sets over a different pH range. Adding the mineral after the gel is set is not always possible in a starch-moulded line. The pH of the matrix and the addition point have to be fixed before the formula is scaled.

Water activity and grit

A chelate that dissolves in water can still feel gritty in a low-water chew if the particles are coarse or the cook is short. Water activity controls both the dissolution of the powder and the texture of the piece over shelf life. Particle size, water activity and processing temperature belong in one trial plan.

Load per piece

At 14% magnesium, 100 mg of elemental magnesium needs about 710 mg of chelate, which can be most of a small gummy's mass. The rest of the piece has to carry the gel, the acid, the flavour and the water. The label claim and the piece weight therefore set the practical load before the formula is written.

Ingredients for this application

Starting points, not a shortlist limit.

Every grade is quoted against the specification and the process, not against the application label.

Next step

Describe the finished product. We will name the grade.

The dose, the process step, the taste and the destination are enough to start a specification review.