Dosage form note · functional beverages

Functional Beverages

Solubility is the entry ticket; pH and heat decide the rest

The brief

A beverage exposes the powder to water, pH, heat and time, so solubility is only the first property to check. Magnesium bisglycinate is water-soluble, but the 5% suspension is alkaline at pH 8.5–11.5, and an acidic drink changes both the pH and the taste profile. Particle size sets the dissolution rate and the clarity after filtration; a fine milled grade clears faster than a coarse crystalline one. Thermal processing adds a second constraint: glycine can react with reducing sugars, so colour and flavour are process variables, not only recipe variables. The mineral load per serving is arithmetic, and the label must name the form. Rainwood supplies the powder; beverage production sits with your manufacturer.

Ready-to-drink still beveragesCarbonated beveragesConcentrates and syrupsInstant beverage powdersProtein-fortified drinks

Matched ingredients

What changes in this format

Three constraints, one grade decision.

The same powder can pass one constraint and fail another. The trial should test all three.

pH is the first formulation variable

The 5% suspension is alkaline at pH 8.5–11.5, and a beverage with a low pH will move the system toward neutrality. That shift can change clarity, taste and the balance of the acid system. Buffer the drink and test it at the intended pH rather than adding the mineral last.

Clarity and particle size

The chelate is water-soluble, but dissolution rate depends on particle size and agitation. A coarse crystalline grade may leave a haze or sediment after a short mix, while an 80-mesh grade clears faster. Filtration and hold time should be tested with the grade that will be used in production.

Thermal processing and colour

Pasteurisation or hot fill adds heat to a solution that already contains glycine and may contain reducing sugars. Browning and flavour drift are process risks that a room-temperature bench mix will not reveal. Run the heat step on the actual beverage matrix and hold it for the intended process time.

Mineral load and taste

The bitterness of a magnesium salt rises with the amount of mineral in the serving, and the alkaline pH can amplify it. Flavour, acid and sweetener have to be balanced against the load, not against a dry powder. The label claim and the serving size should be fixed before the flavour trial.

Ingredients for this application

Starting points, not a shortlist limit.

Every grade is quoted against the specification and the process, not against the application label.

Next step

Describe the finished product. We will name the grade.

The dose, the process step, the taste and the destination are enough to start a specification review.