Dosage form note · capsules

Capsules

Fill weight is a density decision before it is a label decision

The brief

Capsule filling turns bulk density and particle size into a fill weight, so the grade has to be chosen before the capsule size is fixed. A 1:2 magnesium bisglycinate at 13.5–14.2% elemental magnesium is a fine crystalline solid with a pH of 8.5–11.5 in 5% suspension; both figures belong in the capsule specification. Flow, static and moisture migration decide whether the fill runs evenly and whether the shell stays intact. Identity matters too: the capsule label names a chelate, so the batch record has to show the ligand ratio, not only the magnesium assay. Rainwood supplies the powder; filling and shell selection sit with your manufacturer.

Two-piece gelatin capsules, sizes 0–3HPMC (vegetarian) capsules, sizes 0–2Capsule blends with a glidantLow-fill-weight capsules for multi-ingredient formulas

Matched ingredients

What changes in this format

Three constraints, one grade decision.

The same powder can pass one constraint and fail another. The trial should test all three.

Fill weight starts with bulk density

At 0.55–0.90 g/mL, the same capsule volume holds a different mass from lot to lot. A 100 mg elemental magnesium claim needs about 710 mg of a 14% chelate before any excipient, which may decide the capsule size. Ask for bulk density and particle size on the lot, not only the assay.

Flow, static and dust

A 40-mesh crystalline powder flows differently from an 80-mesh milled grade, and fine fractions raise dust and static on a capsule machine. The specification should state the mesh and the bulk density together, because either figure alone predicts little about fill consistency.

Moisture and the capsule shell

The chelate is hygroscopic, and a loss on drying of 2.0% is a limit rather than a target. Water migration between the fill and a gelatin or HPMC shell can change brittleness and appearance during storage. A moisture barrier and a controlled filling room matter as much as the shell polymer.

The label names a chelate

A capsule label that names magnesium bisglycinate has to be backed by the ligand ratio, free glycine and the absence of an undeclared magnesium source. A 14% magnesium result alone does not prove the chelate, because a buffered blend can be formulated to the same figure. Keep the COA, the specification and the label ingredient name aligned before the batch is filled.

Ingredients for this application

Starting points, not a shortlist limit.

Every grade is quoted against the specification and the process, not against the application label.

Next step

Describe the finished product. We will name the grade.

The dose, the process step, the taste and the destination are enough to start a specification review.